ABAC sand blasting guns in dip tube and hopper versions, for rust, paint and scale removal.
A sand blasting gun strips rust, paint and scale by carrying an abrasive in the air stream, which reaches into pitting and profile that a disc cannot and leaves a keyed surface ready to coat. ABAC offers a dip tube version, drawing abrasive from its own container, and a hopper version that holds the abrasive above the gun for longer continuous runs without stopping to refill.
Blasting uses a great deal of air, so the compressor and receiver behind the gun matter more here than for almost any other tool. Abtaz sizes the two together. Send us the surface, the area and the abrasive you intend to use, and we will confirm a gun and the flow and receiver capacity needed to keep it working.
Standard blasting gun with a dip tube, for rust and coating removal.
The standard sand blasting gun, drawing abrasive through a dip tube from its own container. It suits paint, rust and scale removal on larger surfaces where a chemical stripper is not practical.
Blasting gun with a hopper, for continuous work without refilling.
The hopper version, holding the abrasive above the gun so the operator is not stopping to refill a container. It suits the same rust, paint and scale removal over a longer continuous run.
ABAC air impact wrenches from 700 to 4,356 Nm breakaway torque, in 1/2, 3/4 and 1 inch drives, with a twin hammer system.
ABAC air ratchet wrenches in 1/4 and 1/2 inch drives, 41 to 122 Nm, including an impact version with no kickback.
ABAC air sanders: a 10 x 330 mm belt sander at 20,000 rpm and a 150 mm orbital sander with a 5 mm stroke.
ABAC air grinders: angle and long die grinders at 20,000 to 25,000 rpm, a 125 mm angle grinder and a long neck cut-off tool.
ABAC air drills with a 10 mm chuck at 2,000 rpm, reversible, in professional and kit versions.
ABAC air screwdrivers at 1,800 rpm and 8 Nm, in pistol and straight bodies with stepless torque adjustment.
ABAC Saw Comp PRO air body saw at 9,500 rpm and 0.8 kg, for cutting sheet metal and plastic panels.
ABAC air chisel hammers on 10 and 12 mm shanks, 3,000 to 4,500 blows per minute, with stepless impact adjustment.
ABAC air needle scalers with 19 or 28 needles at 3,500 to 3,700 blows per minute, for rust, scale and coating removal.
ABAC air blow guns in standard and lightweight versions, for dedusting, drying and cleaning down.
ABAC paint spray guns in standard, mini and semi-professional versions with adjustable paint and air supply.
ABAC tyre inflators, EC type approved for professional use to 12 bar, in car, truck and DIY versions.
ABAC Combi Nailer G-301, one tool taking both brad nails and staples, for furniture, flooring and modelling.
ABAC air tool kits in 8-piece and 49-piece sets plus a stapling kit, matched to smaller compressors.
Not sure which solution best fits your application? Our engineers are available to review your requirements and help you select the most suitable products and materials for your project.
The Air Tools section of ABAC's current general catalogue, pages 103 to 131, with the specification table for each model in this range (Sand Blasting Gun G-560A, Sand Blasting Gun G-561H), covering air consumption, speed, torque, weight, dimensions and vibration to EN-ISO 28927-9.
DOWNLOAD CATALOGUE